A Pluckeye Forum

A place for Pluckeye users to chew the cud.

You are not logged in.

#1 2020-05-21 08:45:22

KSaddlr
Member
Registered: 2020-05-14
Posts: 12

How to enable Discord with Level 2 Enabled?

Good day to all your Pluckstronauts!

I have been unable to get this software to work despite trying things like 'pluckeye allow discord.exe' - I searched 'Discord' in the search bar above and could not make much sense of the two results I found. If someone would be able to walk me through enabling it that would be ace. Thank you.


lumber <- do not remove me without reading forum rules

Offline

#2 2020-05-21 09:12:11

RNYC
Moderator
Registered: 2017-01-14
Posts: 227

Re: How to enable Discord with Level 2 Enabled?

After you get your console open, if you have Windows, then start by trying to run Discord. Then type this into your console:

pluck verdicts

The output should give you the proper name of the Discord program. For the example below I am assuming the proper name is discord.exe.

Now type this command:

pluck + allow program discord.exe

Wait one delay and technically Discord should be working. If not, use the 'pluck verdicts' again to see if a required website has been blocked..

Offline

Board footer

Powered by FluxBB