A Pluckeye Forum

A place for Pluckeye users to chew the cud.

You are not logged in.

#1 2020-05-12 18:47:03

Cal
Member
Registered: 2019-06-21
Posts: 7

Is there a way to abort changes selectively?

The abort feature is pretty great, since it take just a moment of right thinking for me to reverse a bad decision before it takes effect. But sometimes I have positive changes pending as well, looking something like the following:

# 2020-05-12 17:30:00 + allow everything
# 2020-05-12 16:00:00 + allow jobsearchsite.example

In this example I'd want to use 'abort' to remove the 'allow everything' command, but that's going to remove the pending job site as well. I know I can add it back in manually, but I'd prefer not to if I can help it, especially since that starts the delay cycle over for that particular rule.

Is there a way to cancel some pending changes but not others?



EDIT: Using version 0.99.40 on Windows.

Last edited by Cal (2020-05-12 18:51:04)


lumber

Offline

#2 2020-05-12 21:26:13

RNYC
Moderator
Registered: 2017-01-14
Posts: 230

Re: Is there a way to abort changes selectively?

Unfortunately, I don't believe there is a way to selectively abort yet.

Offline

#3 2020-05-15 19:23:11

Cal
Member
Registered: 2019-06-21
Posts: 7

Re: Is there a way to abort changes selectively?

OK, good to know, thank you.

Anyone else want this feature? Come vote for it on Pluckeye Uservoice!
https://pluckeye.uservoice.com/forums/1 … ut-not-oth


lumber

Offline

Board footer

Powered by FluxBB